From accessory pack to finished print
Follow these five steps in order. Each one includes a short visual so you can check your progress before moving on.
Review the accessory list
Before printing, open the About page to confirm which accessory parts you plan to use, so you print only what a given scene or pose needs.
Open each STL file in your slicing application
Load the accessory's STL file into the slicing application you already use for your 3D printer (for example, one of the widely used open slicing applications). No account setup is needed to open a single STL file.
Check orientation and supports
Use the recommended orientation noted for each part. Most Dummy 13 accessories print best flat-side down, with light support material under any overhanging edges.
Print and finish the part
Print at the layer settings you normally use for small accessory parts. Once complete, remove any support material and test-fit the piece against the Dummy 13 figure before painting or finishing.
Get the accessory pack
You're ready to bring in the files. Use the button below to continue — if you arrived here from elsewhere on the site, this is the same destination.
Distribution link pending — this button currently returns to this step. It will point to the live file listing once published.
DOWNLOAD